Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B

Disassembly/Assembly Removing Exterior Parts/Components 66

4.2.3 Front Cover

 Parts/Components need to be removed in advance: Nothing

 Removal procedure

Open the Front Cover.

2. Raise the CDR Guide Lever to lower the Stacker.

3. While pushing , disengage the left and right positioning holes of the Front

Cover in that order, and remove the Front Cover.

Figure 4-15. Removing the Front Cover (1)

4.2.4 Right Housing / Left Housing / USB Housing

 Parts/Components need to be removed in advance: Nothing

 Removal procedure

 Removing Right/Left Housings

1. Remove the two screws.

• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)

Figure 4-16. Removing the Right/Left Housings (1)

2. Insert a metal straightedge into the slit (ventilating opening) on the Right

Housing and disengage the hook.

3. While pushing , disengage the two tabs, and slide the Right Housing

rearward to remove it. (Refer to Fig.4-18)

Figure 4-17. Removing the Right/Left Housings (2)

Stacker

Front Cover

Positioning Hole

(right)

Positioning Hole

(left)

CDR Guide Lever

[Rear side]

Left Housing

Right Housing

Removal Direction

Push

[Right side]

: Tab

: Hook