Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Exterior Parts/Components 65
4.2 Removing Exterior Parts/Components
4.2.1 Paper Support
 Parts/Components need to be removed in advance: Nothing
 Removal procedure
1. Open the Paper Support.
2. Disengage the right shaft of the Paper Support from the bushing of the ASF
Unit by pushing the bushing outward. Then remove the Paper Support,
disengaging the left shaft preventing the Edge Guide projection from hitting
against the other parts.
Figure 4-11. Removing the Paper Support
l
4.2.2 Printer Cover
 Parts/Components need to be removed in advance: Nothing
 Removal procedure
1. Open the Printer Cover.
2. Pull out the left shaft and right shaft of the Printer Cover in that order, and
remove the Printer Cover.
Figure 4-13. Removing the Printer Cover (1)
When reinstalling the Paper Support, match the projection and
hole of the Edge Guide, then attach the right shaft and the left shaft
in that order. (Put the shafts at the front side in the bushing and
then push them rearward.) After reinstalling, check that the Paper
Support moves smoothly.
Figure 4-12. Reinstalling the Paper Support
Push
Bushing of the ASF
Edge Guide
Projection
: Shaft
Paper Support
Projection
Hole
1
2
Mounting Direction
(from front side to rear side)
Paper Support
: Shaft
When an instruction label needs to be attached, attach it aligning
with the line marked on the back of the Printer Cover. Make sure
it is in the correct orientation as shown below.
Figure 4-14. Attaching the Instruction Label
Shaft (right)
Shaft (left)
Printer Cover
Marking
Instruction Label