Service manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Overview 60
PROTECTION FOR TRANSPORTATION
Before packing the printer to be returned to the user, attach several pieces of strong
tape and vinyl sheet to the specified points to prevent damaging the printer during
transportation.
 Securing the Carriage
(tape: 180mm x 1 pc., fold one end by 5mm)
1. Attach 40mm-length portion of the tape (not folded side) to the left side of the
carriage aligning the tape’s corner with the carriage’s ribs as shown below.
2. Attach the folded side of the tape to the housing with the carriage locked at its
lock position. (First move the carriage to the lock position, then attach the tape
to the housing.)
Figure 4-1. Securing the Carriage
 Securing the Paper Support
(tape: 80mm x 3 pcs., fold one end by 5mm)
Attach the three pieces of strong tape to secure the Paper Support as shown below.
 The left and right tapes should attach to the Paper Support and the side of the
housing.
Figure 4-2. Securing the Paper Support
 Securing the Housing Middle
(tape: 80mm x 2 pcs., fold one end by 5mm)
Attach the two pieces of strong tape to the rear of the MIddle Housing as shown below.
 The tape on the left should not lap over the serial number label.
 The folded end of the tape on the right should align with the fifth ventilating
slit from the right.
Figure 4-3. Securing the Middle Housing on its rear
 Securing the Stacker
(tape: 60mm x 1 pc., fold one end by 5mm)）
Attach the strong tape to the center of the Stacker as shown below.
The edge and backside of the Stacker have irregular steps. Make sure to attach the tape
along the shape.
Figure 4-4. Securing the Stacker
40 mm
Step1
Folded end
Step2
35 mm35 mm
40 mm
Folded end
55 mm 55 mm
Folded end
30mm
Folded end