Operation Manual

Pairing issues
When using the product for the first time, check the following:
1. Attach the PS-100 to the cradle to wake the PS-100 from battery protection mode.
2. Enable Bluetooth
®
communication on your smart device.
3. Check smart device compatibility: epson.com/PSdevices
4. Ensure your smart device is connected to the Internet.
5. Remove any other product from the area that could interfere with the Bluetooth
®
communication.
If pairing is lost or the PS-100 has been paired with another smart device, check the following:
1. The PS-100 may already be un-paired.
Put the PS-100 into the cradle and tap it until you see the blue LED s flash back and forth twice.
2. The PS-100 already been deleted from PULSENSE View.
3. The PS-100 already been deleted in the Bluetooth® settings of your smart device.
4. Make sure Bluetooth
®
communication been enabled on your smart device.
5. Check smart device compatibility:epson.com/PSdevices
6. Ensure your smart device is connected to the Internet.
7. Remove any other product that could interfere with the Bluetooth
®
communication
Set up and basic operation • 19