Operation Manual

Selecting Projector Network Settings
9
Follow these instructions to select a connection method between a computer
and the projector, and then set up the projector.
Connect the projector to your network using the Advanced connection mode.
gg Related Links
• "Setting Up a Projector to Connect in Advanced Connection Mode (Wired)"
p.9
• "Setting Up a Projector to Connect in Advanced Connection Mode
(Wireless)" p.9
Setting Up a Projector to Connect in Advanced
Connection Mode (Wired)
To connect a computer to the projector using a wired LAN, you need to select
network settings on the computer and the projector.
a
Connect the computer to the network.
a
To set up a network connection, if necessary, see the
documentation supplied with your computer or network adapter.
b
Connect a LAN cable to the projector.
c
Turn on the projector.
d
Press the [Menu] button on the remote control or the control panel,
select the Network menu, and select Network Configuration.
e
Select Wired LAN.
A screen like one of the following is displayed.
f
Set DHCP to Off and enter the projector's IP Address, Subnet Mask,
and Gateway Address values as necessary.
g
When you have finished making settings, select Setup Complete or
Complete, and follow the on-screen instructions to save your settings
and exit the menus.
gg Related Links
• "Solutions When You Cannot Connect Projectors Using Advanced
Connection Mode (Wired)" p.30
Setting Up a Projector to Connect in Advanced
Connection Mode (Wireless)
To connect a computer to the projector over a wireless LAN, you need to
select network settings on the computer and the projector.
a
Contact your network administrator and write down the settings for the
access point, such as the SSID and security settings.
b
Connect the computer to the network.