Operation Manual

Solving Network Connection Problems
31
• Set the IP address, the subnet mask, and the gateway address for the
projector correctly.
• Turn on a wireless LAN.
• Set the wireless LAN system to meet the standards supported by the access
point.
• When you enable the security setting, set the same passphrase to the
access point, the computer, and the projector.
• Close network settings on the projector, and then return to the LAN
standby screen.
• Check the computer's network settings.
• If the wireless LAN adapter is not installed on your computer, install a
wireless LAN card on your computer.
• Enable the wireless LAN setting or AirPort on your computer.
• Connect to the access point to which the projector is connected.
• Turn off the firewall. If you do not want to turn it off, register the firewall
as an exception. Make the necessary settings to open the ports. The ports
used by this software are "56181" (TCP).
• Check the access point settings.
• Set connection permission at the access point to allow projectors to
connect if any functions that block connections, such as MAC Address
restrictions and port restrictions, are set to the access point.
gg Related Links
• "Setting Up a Projector to Connect in Advanced Connection Mode
(Wireless)" p.9