user manual
Table Of Contents
- Notations Used in This Guide
- Contents
- Projector Features
- Part Names and Functions
- Useful Functions
- Changing the Projected Image
- Functions for Enhancing Projection
- Selecting the Projection Quality (Selecting Color Mode)
- Setting the Auto Iris
- Hiding the Image and Sound Temporarily (A/V Mute)
- Freezing the Image (Freeze)
- Changing the Aspect Ratio
- Pointer Function (Pointer)
- Enlarging Part of the Image (E-Zoom)
- Using the Remote Control to Operate the Mouse Pointer (Wireless Mouse)
- Restrictions in the Target Projector when Using Multiple Projectors
- Correcting Color for Multiple Projectors (Multi-Screen Color Adjustment)
- Security Functions
- Configuration Menu
- Troubleshooting
- Appendices
- Installation Methods
- Cleaning
- Replacing Consumables
- Optional Accessories and Consumables
- Saving a User's Logo
- Making a WPS (Wi-Fi Protected Setup) Connection with a Wireless LAN Access Point (EB-1735W/1725/1723 only)
- Screen Size and Distance
- Connecting and Removing USB Devices (EB-1735W/1725/1723 only)
- Connecting with a USB Cable and Projecting (USB Display EB-1735W/1725/1723 only)
- Reading Problem Mail Notification Function (EB-1735W/1725/1723 only)
- ESC/VP21 Commands
- Regarding Network Projector (EB-1735W/1725/1723 only)
- About PJLink
- List of Supported Monitor Displays
- Specifications
- Appearance
- Glossary
- Index
Security Functions
34
B
Turn on "Power On Protect".
(1) Select "Power On Protect", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
C
Turn on "User's Logo Protect".
(1) Select "User's Logo Protect", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
D
Turn on "Network Protect". (EB-1735W/1725/1723
only)
(1) Select "Network Protect", and then press the [Enter] button.
(2) Select "On", and then press the [Enter] button.
(3) Press the [Esc] button.
E
Set the password.
(1) Select "Password", and then press the [Enter] button.
(2) The message "Change the password?" is displayed, select
"Yes" and then press the [Enter] button. The default setting for
the password is "0000". Change this to your own desired
password. If you select "No", the screen shown in step 1 is
displayed again.
(3) While holding down the [Num] button, enter a four digit
number using the numeric buttons. The number entered is
displayed as "* * * *". When you enter the fourth digit, the
confirmation screen is displayed.
(4) Re-enter the password.
The message " Password accepted." is displayed.
If you enter the password incorrectly, a message is displayed
prompting you to re-enter the password.
Remote control
Numeric buttons
Keep pressed