User Setup Information

You see the prompt Enter

Password Again.

Type your

password and press

[ThePasswordoptionsetting

changes to Set.

Note

Be sure to remember the password you enter or write it

down and keep it in a safe place. If you cannot

remember it, you will not be able to use the computer

the next time you turn it on. If you forget your

password, however, there is a way to access your

system. See “Password Problems” in Chapter 7 of the

User’s Guide

for more information.

8. If you will be using your computer as a network server and

want to set your password to operate in a special network

security mode, highlight Network server mode and

press

Enbr

Then press [+1 or

to change the setting

from Not

installed to Installed. (See ”Using Your

Computer as a Network Server” in Chapter 1 of the

User’s

Guide

for information about network server mode.)

Note

To provide complete security, be sure to lock the cover onto

your computer. See Chapter 1 of the

User’s Guide

for

instructions.

After you set a password, you can change or delete it when you

are using the SETUP program or when you are entering the

password to access your computer. Follow the steps in the

appropriate section below to change or delete an existing

password in SETUP. See Chapter 1 of the

User’s Guide

for

instructions on entering, changing, and deleting your password

as you access your computer.

2-16

Running

the

SETUP Program