User Setup Information

Note
Be sure to set the jumpers on any parallel or serial port
option card(s) you install to indicate how you want the
port(s) to be assigned. The SETUP options do not assign the
addresses for any port installed on an option card. See the
instructions that came with the card(s) for the correct jumper
settings.
Setting the Speaker
If you want the computer’s built-in speaker to beep during
certain operations you may perform, select Enabled for the
Speaker option (the default setting). If you do not want to
hear the speaker, select disabled.
If you enable the speaker, you can adjust its volume using the
SETVOL utility. See Chapter 1 of the User’s Guide for
instructions.
Setting the Disk Drive Controllers
If you are using the standard drive(s) that came with your
computer, you should set the Internal diskette drive
controller and Internal hard disk drive
controller options to Enabled (the default settings).
However, if you install an option card to provide a controller
for a diskette drive or hard disk drive, select Disabled for the
appropriate controller option(s).
2-14 Running the SETUP Program