Setup guide

You can also disable power-on diagnostic testing of your cache

if you are receiving cache errors that prevent you from using

your computer. This way, you can perform any steps necessary

to diagnose the problem as you obtain technical assistance. (The

default

setting

for

the POD Internal cache

test option is

Enabled.)

Note

Neither of the cache options described in this section affect

your system’s Virtual Cache

™

feature.

Saving Your Settings and Exiting SETUP

The way in which you exit the SETUP program depends on

whether you have changed the settings of any SETUP options

and whether or not you want to save these changes. For

example, you can do one of the following to exit SETUP:

Make no changes and exit

Save your changes and exit

Not save your changes and exit.

Follow the steps in the appropriate section below to save your

settings and exit SETUP. If you have just run SETUP for the

first time, also be sure to read “Post-SETUP Procedures” at the

end of this chapter for further instructions on setting up your

computer.

Note

You can also save your changes and remain in SETUP by

pressing

[

any time you are using the program.

Running the SETUP Program

2-25