Setup guide

Defining your own drive type
If the parameters for your hard disk that are listed in its
documentation do not match any of the types listed in the table
above, you can define your own type. Follow these steps:
1. Highlight the Hard disk 1: or Hard disk 2 : option
and press [Marl
2. Press [nl. You see the following prompt in the middle of
the screen:
Enter number of cylinders on disk
3. Use the numeric keys along the top of the keyboard or on the
numeric keypad (with the num lock function turned on) to
enter the appropriate value for the number of cylinders on
your hard disk. (If you make a mistake, press <-
t!iFiGG
to
erase the value before you go to the next step.)
4. Press [Enbr). You see a prompt to enter the number of
cylinder (read/write) heads on the drive.
5. Type the correct value as described in step 3 and press [Enbrl.
6. You see a prompt to enter the number of sectors per track on
the disk. T
dr
the correct value as described in step 3 and
press m .
You do not enter a value for the drive size; SETUP does this
automatically based on the other parameters.
SETUP displays your hard disk drive type as UD followed by
the parameters you entered.
2-22 Running the SETUP Program