Setup guide

SETUP may detect a built-in or optional math coprocessor on
your computer’s CPU card. You see Yes at the Math
coprocessor option if SETUP detects a math coprocessor or
No if it does not detect one.
Setting the Built-in Parallel and Serial Port Options
There are two sets of options you can use to control the
operation of your built-in parallel and serial ports: the primary
port options and the I/O address options. The primary port
options are listed under the I / O Ports heading and the I/O
address options are listed under the Port
Configuration
heading. The table below lists the options and their available
settings.
Parallel and serial port options
~~
Primary serial l/O address 3F8h - COM 1 ‘, 2F8h - COM2,
338h - COM3.238h - COM4
I
’ Default setting
The default setting for both the parallel and serial port is
Enabled. The default I/O address setting for both ports is
primary (LPT1 for the parallel port and COM1 for the serial
pm.
If you have not installed any additional ports, you do not need
to change any settings.
2-12 Running the SETUP Program