Setup guide

0 Type(s) of diskette and hard disk drive(s) installed
0 Cache, cache testing, and non-cacheable address operation
for the internal cache.
The configuration you define through SETUP is stored in a
special area of memory called CMOS RAM. This memory is
backed up by a battery, so it is not erased when you turn off or
reset the computer. Whenever you reboot the computer, it
checks the settings, and if it discovers a difference between the
information in the CMOS RAM and its actual hardware
configuration, it prompts you to run SETUP. You see a message
such as the following:
Memory size mismatch
(Run SETUP)
Press <P2> to run SETUP
If this happens, press m to run SETUP and correct the
setting as described in this chapter.
Starting the SETUP Program
To start SETUP, turn on your computer. (If the computer is
already on, press the RESET button to reset it.) As soon as you
see the following prompt, press [
Press <F2> to run SETUP
Note
If you do not press [F21 within five seconds, the computer
tries to load the operating system and you will not be able to
run SETUP. If this happens, reset the computer to try again.
2-2 Running the SETUP Program