User Setup Information

Note

Be sure to set the jumpers on any parallel or serial port

option card(s) you install to indicate how you want the

port(s) to be assigned. The SETUP options do not assign the

addresses for any port installed on an option card. See the

instructions that came with the card(s) for the correct jumper

settings.

Setting the Speaker

If you want the computer’s built-in speaker to beep during

certain operations you may perform, select

Enabled for the

speaker

option (the

default setting). If you do not want to

hear the speaker,

select Disabled.

Setting the Disk Drive Controllers

you

are using the standard drive(s) that came with

your

computer, you should

set the

Internal

diskette drive

controller and Internal

hard disk drive

controller options to Enabled (the default settings).

However, if you install an option card to provide a controller

for a diskette drive or hard disk drive, select

Disabled for the

appropriate controller option(s).

Running the SETUP Program

2-15