User's Manual

To run ESPEED,
prompt and
the following at the MS-DOS command
ESPEED
You see the following messages:
Wage: ESPEEDt/H] t/L] [/Al
/High
6et High 6peed (no Auto)
/LOW
6et LOW speed (no Auto)
/Auto met Auto rrpeed
These messages tell you the switches you should use to set the
speed to high, low, or automatic. At the MS-DOS prompt, type
the ESPEED command again and include the appropriate
switch, such as the following:
ESPEED /A
(This command sets the processor speed to change to low speed
automatically when the computer accesses a diskette.)
If you include the switch when you type the initial ESPEED
command, the program changes the speed without displaying
the command options.
The processor speed you set
remains in effect until you change
1-32 Using Your Computer