User Manual SCANNER ES-1200C

Note: l

Keep the shipping screw in a safe place; you will need it if

you should need to transport the scanner. When

transporting the scanner, you should remove the

transparency unit and reattach the shipping screw.

l If the unit’s lamp assembly is not in its initial position, you

cannot attach the shipping screw. If this happens,

reattach the unit to the scanner, close the unit, and turn

the scanner on; the unit’s lamp assembly then returns to

its initial position. Then turn off the scanner and remove

the transparency unit.

Installing the Transparency

Unit on the Scanner

Follow the steps below to install the transparency unit on the

scanner.

1. Make sure the scanner’s power switch is turned off and remove

the power cable from the scanner.

2. Remove the document cover from the scanner.

3. The scanner comes with two mounting screws attached; slide the

mounting slots on the transparency unit forward underneath

these two screws.