User`s guide

77
Chapter4 Development Guide for a Cooperative Application
4
Stacker 3 HST3000 The number of discs in the stacker 3 has exceeded the upper
limit.
Remedy:
Remove discs so that the number of discs in the stacker 3 falls
within the limit.
HST3001 The stacker 3 has not been installed in Batch mode.
Remedy:
Install the stacker 3.
HST3002 The stacker 3 has been installed in Standard or External Output
mode.
Remedy:
Remove the stacker 3.
Disk cover HDC000 The disc cover is open.
Remedy:
Close the disc cover
Communication HNW000 Either one of the following communication errors occur.
• Communication with PP-100/PP-100N is disabled.
• The filter driver has not been attached.
Remedy:
[For PP-100]
(1) Check the power supply of the PP-100.
(2) Check if the USB cable is securely connected.
(3) Connect the publishing machine, and turn on the power.
[For PP-100N]
(1) Check the power supply of the PP-100.
(2) Check if the network cable is securely connected.
HNW001 A non-supported version error has occurred, and any of the
following has been detected.
(1) Firmware version of the auto loader is not supported.
(2) Firmware version of the drive 1 is different from the
supported version.
(3) Firmware version of the drive 2 is different from the
supported version.
(3) Firmware version of the printer is not supported.
Remedy:
Upgrade the firmware of the concerning device.
Item
INFORMATION
code
Explanation and Remedies