User`s guide

Chapter 3 Setting

Select [System settings] - [Output device]. Following settings can be made.

Setting Item Explanation

Device name You can change the name of PP-100N.

Publish

mode

Mode Select the publishing mode from the following three options;

“Standard Mode”, “External Output Mode”, and “Batch

Mode”. See the PP-100N User’s Guide for more information on

the publishing mode.

Stacker 1, 2 When “Standard Mode” is selected:

Select disc type for Stacker 1 that is used for blank discs.

Stacker 2 is used for ejected (published) discs.

When “External Output Mode” is selected:

Select disc type for both Stacker 1 and 2 that are used for blank

discs.

When “Batch Mode” is selected:

Select disc type for both Stacker 1 and 2 that are used for blank

discs. An error occurs if the disc type specified for Stacker 1 and

2 is different from that specified in the JDF file.

Drive

Settings

Drive used Select the drive to be used for writing data to the blank discs.

Select one from the following three options; “Use Both”, “Use

Drive 1 Only”, and “Use Drive 2 Only”.

Number of write

retries

Specify the number of retries in the case of writing errors. The

number can be entered in the range of 0 to 9.

Printer

Settings

Show error mark on

discs that

experience errors

Tick the checkbox when you want to print an error mark on

published discs that may have been improperly burnt (an error

occurs during writing). This helps you to separate the failed

discs from the normal ones.