User`s guide

SD command parameters (continued)
Parameter
/K
Mode
Keyboard only
mode
Function
Sets the program so a mouse
cannot be used, even if you have
installed one. In default mode, you
can use a mouse as long as a
mouse driver is loaded.
/M
Monochrome
display mode
Causes the program to be
displayed in black and white only.
In default mode, color monitors will
display in color. Run the program in
this mode if you have redirected
the console output to a serial port.
/N
Non-target
Allows you to run the EISA
modeling mode Configuration utility in non-target
modeling mode; see page 3-25 for
more information.
/P
Permanent
Causes the configuration program
command
to reboot the system instead of
interpreter mode exiting to your operating system.
Use this mode if there is no
COMMAND.COM file installed on
your hard disk drive.
Using the CF Command
If you want to run the EISA Configuration utility from your
hard disk, first follow the instructions under “Copying the
Configuration Files to a Hard Disk” on page 3-31.
Then follow these steps to use the CF command:
1. To run the utility from a diskette, insert the Reference
diskette in drive A and log onto drive A. To run the utility
from a hard disk, log onto the drive and directory where
you copied the configuration files.
Running the EISA Configuration Utility
3-29