User`s guide

Starting the Program
Follow these steps to run SETUP:
1.
Turn on the computer or press the reset button. You see the
memory test countdown and then the power-on diagnostic
test countdown. You may also see this prompt:
Press Spacebar to Abort Memory Test
If you want to skip the memory test to shorten the time it
takes to enter SETUP, press the spacebar.
(If you press [Ctrl) 171 [E] to reset the computer, it
does not perform the memory test.)
2.
If the power-on diagnostic tests do not find errors, you hear
a beep and may see the following prompt:
To continue press: . . . . . . . SPACEBAR
To configure system press: . . . F1
remains on the screen for four seconds. Press
If the tests find a minor error or you have not yet installed
your operating system, the computer beeps twice; then you
see an error message and the following prompt:
To continue press: . . . . . . . SPACEBAR
To configure system press: . . . F1
2-2 Running the SETUP Program