Manualshelf

User`s guide

ManualsBrandsEpson ManualsComputer equipmentPowerspan
141142143144145146147148149150
If your system came with a SCSI adapter and a SCSI drive, this
cable is already connected inside your computer. If your
computer did not come with a SCSI subsystem, this cable came
in the box with your computer.
Follow the steps below to connect the SCSI ribbon cable to your
adapter and drives. If the SCSI adapter and at least one SCSI
drive are installed, begin with step 3.
1.
Connect P1 of the SCSI ribbon cable to the SCSI adapter you
installed on the main system board.
2.
To route the cable from the SCSI adapter to the first drive,
guide the cable underneath the adapter and into the gap
between the lower SCSI drive bays and the bottom of the
computer, as shown below.
SCSI
adapter
Pl
’
gap
P2
Installing and Removing Disk Drives
7-23