Specifications

5-66
Hardkey/Softkey Reference
Analyzer Functions
leads to the transmission menu.
presents the trigger menu, which is used to select the type
and number of the sweep trigger.
turns off external trigger mode.
selects the 85052C cal kit.
leads to the TRL*/LRM* 2-port calibration menu.
selects the TRL/LRM Option Menu, under the modify cal
kit menu.
is used to enter the standard numbers for the TRL LINE
or MATCH class.
is used to enter the standard numbers for the TRL THRU
class.
is used to enter the standard numbers for the TRL
REFLECT class.
sets the TTL output (TEST SEQ BNC) on the back of the
analyzer high.
sets the TTL output (TEST SEQ BNC) on the back of the
analyzer low.
sets the analyzer to function as a tuned receiver only,
disabling the source.
allows the marker stimulus values to be controlled
independently on each channel.
sends the sum frequency of the RF and LO to the R
channel.
sets the upper limit value for the start of the segment. If a
lower limit is specified, an upper limit must also be
defined. If no upper limit is required for a particular
measurement, force the upper limit value out of range (for
example +500 dB).
When or is pressed, all
the segments in the table are displayed in terms of upper
and lower limits, even if they were defined as delta limits
and middle value.
If you attempt to set an upper limit that is lower than the
lower limit, or vice versa, both limits will be automatically
set to the same value.
TRANSMISSION
TRIGGER MENU
TRIGGER: TRIG OFF
TRL 3.5 mm 85052C
TRL*/LRM* 2-PORT
TRL/LRM OPTION
TRL LINE OR MATCH
TRL THRU
TRL REFLECT
TTL OUT HIGH
TTL OUT LOW
TUNED RECEIVER
UNCOUPLED
UP CONVERTER
UPPER LIMIT
UPPER LIMIT
LOWER LIMIT