Specifications

DISPlay Subsystem ZVx
1043.0009.50 3.50 E-15
DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y[:SCALe]:OFFSet
This command defines an offset value to be added to the output values. In addition to the units given
in the table, the following units and prefixes are permitted for the individual measured quantities:
Power: DBM, DBW, MW, UW, NW, PW
Voltage: V, MV, UV, NV, PV,
Phase: DEG, KDEG, MDEG, UDEG, NDEG, PDEG
Group delay: S, MS, US, NS, PS
Impedance: OHM, GOHM, MOHM, KOHM
Admittance: SIE, MSIE, USIE, NSIE
Inductivity: H, MH, UH, NH, PH, FH
Capacitance: F, MF, UF, NF, PF, FF
Dimensionless: UNIT, MUNIT, UUNIT, NUNIT, PUNIT, FUNIT
Syntax: DISPlay[:WINDow[1 to 4]:TRACe[1|2]:Y[:SCALe]:OFFSet <numeric_value>
Example: "DISP:TRAC:Y:OFFS -6dBm"
Features: *RST value: 0dB
SCPI: device-specific
DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y:SPACing
This command toggles between linear and logarithmic scaling of the Y-axis.
Syntax: DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y:SPACing LINear | LOGarithmic | dB
Example: "DISP:TRAC:Y:SPAC LIN"
Features: *RST value: LOGarithmic
SCPI: conforming
DISPlay[:WINDow[1...4]]:TRACe[1|2]:R[:SCALe]:CPOint
This command defines the center value of the polar diagram.
Syntax:
DISPlay[:WINDow[1...4]]:TRACe[1|2]:R[:SCALe]:CPOint <numeric_value>
Example:
"DISP:TRAC:R:CPO"
Features:
*RST value:
SCPI: conforming
DISPlay[:WINDow[1...4]]:TRACe[1|2]:R[:SCALe]:OEDGe
This command defines the radius of the polar diagram.
Syntax:
DISPlay[:WINDow[1...4]]:TRACe[1|2]:R[:SCALe]:OEDGe <numeric_value>
Example:
"DISP:TRAC:R:OEDG"
Features:
*RST value:
SCPI: conforming
DISPlay[:WINDow[1...4]]:TRACe[1|2]:R:SPACing
This command switches between linear and logarithmic representation.
Syntax:
DISPlay[:WINDow[1...4]]:TRACe[1|2]:R:SPACing LINear | LOGarithmic | dB
Example:
"DISP:TRAC:R:SPAC LIN"
Features:
*RST value:
SCPI:
LOGarithmic
conforming