Specifications

DISPlay Subsystem ZVx
1043.0009.50 3.48 E-15
DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y[:SCALe]:RLEVel
This command defines the reference level. In addition to the units given in the table, the following
units and prefixes are permitted for the individual measured quantities:
Power: DBM, DB, DBW, W, MW, UW, NW, PW
Voltage: V, MV, UV, NV, PV, DBV, DBMV, DBUV
Phase: DEG, KDEG, MDEG, UDEG, NDEG, PDEG
Group delay: S, MS, US, NS, PS
Impedance: OHM, GOHM, MOHM, KOHM
Admittance: SIE, MSIE, USIE, NSIE
Inductivity: H, MH, UH, NH, PH, FH
Capacity: F, MF, UF, NF, PF, FF
Dimensionless: UNIT, MUNIT, UUNIT, NUNIT, PUNIT, FUNIT
Syntax: DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y[:SCALe]:RLEVel <numeric_value>
Example: "DISP:TRAC:Y:RLEV -60dBm"
Features: *RST value: –
SCPI: conforming
The specification of the reference level depends on the unit currently selected.
DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y[:SCALe]:PDIVision
This command defines the distance between two grid lines. In addition to the units given in the table,
the following units and prefixes are permitted for the individual measured quantities:
Power: DBM, DBW, MW, UW, NW, PW
Voltage: V, MV, UV, NV, PV, DBV,
Phase: DEG, KDEG, MDEG, UDEG, NDEG, PDEG
Group delay: S, MS, US, NS, PS
Impedance: OHM, GOHM, MOHM, KOHM
Admittance: SIE, MSIE, USIE, NSIE
Inductivity: H, MH, UH, NH, PH, FH
Capacity: F, MF, UF, NF, PF, FF
Dimensionless: UNIT, MUNIT, UUNIT, NUNIT, PUNIT, FUNIT
Syntax: DISPlay[:WINDow[1 to 4]]:TRACe[1 to 4]:Y[:SCALe]:PDIVision numeric_value>
<numeric_value>::=
Example: "DISP:TRAC:Y:PDIV 10dB"
Features: *RST value: 10 dB
SCPI: conforming
DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y[:SCALe]:RPOSition
This command defines the reference position in percent.
Syntax: DISPlay[:WINDow[1 to 4]]:TRACe[1|2]:Y[:SCALe]:RPOSition <numeric_value>
<numeric_value>::=
Example: "DISP:TRAC:Y:RPOS 50 PCT"
Features: *RST value: 100PCT
SCPI: device-specific
Value 100% corresponds to the reference level (TOP), value 0% corresponds to the bottom of the
grid (BOTTom).