Specifications

ZVx Common Commands
1043.0009.50 3.17 E-15
3.6.2 Common Commands
The common commands are taken from the IEEE 488.1 (IEC 625-2) standard. Same commands have
the same effect on different devices. The headers of these commands consist of an asterisk "*" followed
by three letters. Many common commands refer to the status reporting system which is described in
detail in Section 3.8.
Command Designation Parameter Remark
*CAL? Calibration Query query only
*CLS Clear Status no query
*ESE Event Status Enable 0 to 255
*ESR? Standard Event Status Query query only
*IDN? Identification Query <string> query only
*IST? Individual Status Query query only
*OPC Operation Complete
*OPT? Option Identification Query query only
*PCB Pass Control Back 0 to 30 no query
*PRE Parallel Poll Register Enable 0 to 255
*PSC Power On Status Clear 0 | 1
*RST Reset no query
*SRE Service Request Enable 0 to 255
*STB? Status Byte Query query only
*TRG Trigger no query
*TST? Self Test Query query only
*WAI Wait to continue no query