Specifications

Index ZVx
1127.8700.12 I.10 E-3
Softkey
ENABLE DEV1 / DEV2.........................................2.163
GENERAL SETUP ...............................................2.142
MONITOR CONNECTED.....................................2.147
SETTINGS DEVICE 1/2.......................................2.162
Softkey
display....................................................................2.59
EXT SRC CONFIG...............................................2.130
IEC/IEEE bus .........................................................2.59
menu ......................................................................2.59
related IEC/IEEE-bus commands .........................3.160
Softkey TRANS NORM (ZVRL) ..................................2.338
SOI.................................................................. 2.132, 3.107
SORT MODE..............................................................2.168
SOURCE (key) ...........................................................2.207
Span...........................................................................2.189
SPAN (key)...................................................... 3.103, 3.119
SPAN (key).................................................................2.189
SPAN = MARKER ......................................................2.230
SRC POWER MAX LIMIT (compression point)
............................................................. 2.128, 3.117, 3.118
SRC POWER MAX LIMIT (SOI).................................2.133
SRC POWER MAX LIMIT (TOI) .................................2.133
SRC POWER MIN LIMIT (compression point)
............................................................. 2.128, 3.117, 3.118
SRC POWER MIN LIMIT (SOI) ..................................2.133
SRC POWER MIN LIMIT (TOI)...................................2.133
SRQ
indication..............................................................2.182
Stability factor.............................................................2.263
Standby ........................................................................1.21
Standing wave ratio....................................................2.267
START (key)................................ 2.189, 3.57, 3.103, 3.119
START = MARKER ........................................... 2.229, 3.36
START AUTOKAL......................................................2.321
START NEW CAL ......................................................2.300
START NEW POWER CAL........................................3.116
START POWER CAL .................................................2.355
Start value ..................................................................2.189
Start-Up........................................................................1.20
Status registers...........................................................3.151
Status reporting service request .................................3.157
Status reporting system..............................................3.147
error queue query.................................................3.158
parallel poll...........................................................3.158
queries .................................................................3.158
reset values..........................................................3.159
serial poll..............................................................3.157
use .......................................................................3.157
STEEP EDGES................................................. 2.101, 3.21
STEEP FALLOFF..............................................2.111, 3.42
STEEPEST EDGES ..........................................2.100, 3.21
STEP (key)...................................................................2.94
STEP APERTURE.............................................2.267, 3.23
STEP ATT a1 .................................................... 2.209, 3.72
STEP ATT a1 AND a2....................................... 2.209, 3.72
STEP ATT a2 .................................................... 2.210, 3.72
STEP ATT b1 .................................................... 2.210, 3.62
STEP ATT b2 .................................................... 2.210, 3.62
STEP SIZE...................................................... 2.200, 3.113
Stepsize
settings...................................................................2.94
STIMULUS (key group) ..............................................2.189
STOP (key)........................................... 2.189, 3.103, 3.119
STOP = MARKER ............................................. 2.229, 3.36
Stop value ..................................................................2.189
SUPER COMPACT ....................................................2.174
SUPERCOMPACT .......................................................3.53
Sweep
indikator..................................................................2.57
SWEEP (key group) ...................................................2.191
SWEEP (key) .............................................................2.191
SWEEP DIR FWD/REV ...................................2.205, 3.113
Sweep direction.......................................................... 2.205
Sweep line ................................................................... 2.57
Sweep modes ............................................................ 2.138
Sweep segments........................................................ 2.194
SWEEP SEGMENTS (selection table)....................... 2.195
SWEEP START/HOLD .............................................. 2.205
Sweep time ................................................................ 2.203
automatic setting.................................................. 2.203
manual setting...................................................... 2.203
SWEEP TIME AUTO/MAN...............................2.203, 3.112
SWEEP TYPE..................................................2.138, 3.107
switch-on test................................................................. 4.2
SWR ..............................................2.221, 2.267, 3.22, 3.31
SYMMETRIC NETWORK .......................................... 2.311
SYSTEM (key group) ................................................... 2.97
System error .............................................................. 2.298
System error calibration ............................................. 2.299
System messages..............................................2.76, 2.153
SYSTEM MESSAGES ............................................... 2.153
System-error correction.............................................. 2.213
T
Table
operation................................................................ 2.85
scrolling ................................................................. 2.87
TAKE CAL SWEEP..........................................2.368, 3.120
TARGET MODE........................................2.224, 3.33, 3.34
Target search mode ................................................... 2.224
TCP/IP
operation................................................................ 1.53
Terminating admittance.............................................. 2.261
Terminating impedance.............................................. 2.261
Test parameter
information............................................................. 2.50
Test Sequence
ZVC, ZVCE............................................................ 5.53
ZVR, ZVRE, ZVRL................................................... 5.2
Testing the Rated Specifications.................................... 5.1
Thick Ethernet.............................................................. 1.44
Thin Ethernet ............................................................... 1.43
THIRD HARMONIC..........................................2.118, 3.104
THROUGH (ONE PATH, ZVR) ..........................2.330, 3.92
THROUGH (ONE PATH, ZVRL).........................2.332, 3.92
THROUGH (TNA)...............................................2.311, 3.92
THROUGH (TOM)..............................................2.306, 3.92
THROUGH (TOM-X) ..........................................2.314, 3.92
THROUGH (TOSM) ...........................................2.313, 3.92
THROUGH (TOSM, ZVRE)................................2.318, 3.92
THROUGH (TRANS AND REFL NORM, ZVR) ..2.337, 3.92
THROUGH (TRANS AND REFL NORM, ZVRL) 2.340, 3.92
THROUGH (TRANS NORM, ZVR).....................2.333, 3.92
THROUGH (TRANS NORM, ZVRL)...................2.338, 3.92
THROUGH (TRL)...............................................2.309, 3.92
THROUGH (TRM)..............................................2.308, 3.92
Time
input..................................................................... 2.147
TIME ................................................................2.147, 3.139
Time domain ................................................................ 3.20
TIME DOMAIN..........................................2.98, 2.176, 3.54
TIME GATE......................................................... 2.99, 3.20
Time sweep................................................................ 2.139
TIME SWEEP ..................................................2.139, 3.107
TINT........................................................................... 2.288
TITLE......................................................................... 2.291
Title line .............................................................2.49, 2.291
TNA....................................................................2.311, 3.93
TOI...................................................................2.132, 3.107
Tolerance band .......................................................... 2.239
Tolerance circles........................................................ 2.236
TOM...................................................................2.305, 3.93