Specifications

ZVx Status Reporting System
1043.0009.50 3.155 E-15
3.8.3.5 STATus:QUEStionable-Register
This register contains information on questionable instrument states. Such states can occur, e.g. if the
instrument is operated outside its specifications. It can be read using commands
STATus:QUEStionable:CONDition? or STATus:QUEStionable[:EVENt]?
Table 3-5 Meaning of the bits used in the STATus:QUEStionable register
Bit No. Meaning
0
VOLTage
This bit is set if a questionable voltage occurs.
1
CURRent
This bit is set if a questionable current occurs.
2
TIME
This bit is set if a questionable time occurs.
3
POWer
This bit is set if a questionable power occurs.
4
TEMPerature
This bit is set if a questionable temperature occurs.
5
FREQuency
The bit is set if a frequency is questionable.
6
PHASe
The bit is set if a phase value is questionable.
7
MODulation
The bit is set if a modulation is performed questionably.
8
CALibration
The bit is set if a calibration is not performed properly.
9
LIMiit
The bit is set if one of the limit values is exceeded (see also Section 3.8.3.6,
STATus:QUEStionable:LIMit-Register)
10-12 Not used.
13
INSTrument Summary Bit
This bit is set when one or more logical instruments is reporting a message.
14
COMMand Warning
This bit is set if the instrument ignores parameters when executing a command.
15 This bit is always 0.
The network analyzer supports bits 5 and 9.