Specifications

ZVx SYSTem Subsystem
1043.0009.50 3.135 E-15
SYSTem:COMMunicate:RDEVice:PMETer:CFACtor:ASENsor
This command defines the sensor factor list for sensor A which can be active for a power calibration.
Syntax:
SYSTem:COMMunicate:
RDEVice:PMETer:CFACtor:ASENsor
<numeric_value>,<numeric_value>,
<numeric_value> ...
Example:
"SYST:COMM:RDEV:PMET:CFAC:ASEN 2,10HZ,99PCT,4GHZ,98PCT"
Features:
*RST value:
SCPI:
0 (i.e. sensor factor list empty)
conforming
The parameters are sorted as follows:
number of following (frequency, factor) pairs (0 .. 20)
frequency 1 (10 Hz .. 4 GHz)
faktor for frequency 1 (0 PCT .. 100 PCT)
...
The frequencies must be sorted in ascending order.
SYSTem:COMMunicate:RDEVice:PMETer:CFACtor:BSENsor
This command defines the sensor factor list for sensor B which can be active for a power calibration.
Syntax:
SYSTem:COMMunicate:
RDEVice:PMETer:CFACtor:BSENsor
<numeric_value>,<numeric_value>,
<numeric_value> ...
Example:
"SYST:COMM:RDEV:PMET:CFAC:BSEN 2,10HZ,99PCT,4GHZ,98PCT"
Features:
*RST value:
SCPI:
0 (d.h leere Sensor-Faktor-Liste)
conforming
The parameters are sorted as follows:
number of following (frequency, factor) pairs (0 .. 20)
frequency 1 (10 Hz .. 4 GHz)
faktor for frequency 1 (0 PCT .. 100 PCT)
...
The frequencies must be sorted in ascending order.
SYSTem:COMMunicate:RDEVice:PMETer:AZERo[:STATe]
This command defines whether the automatic zeroing of the power meter is performed for a power
calibration.
Syntax:
SYSTem:COMMunicate:RDEVice:PMETer:AZERo[:STATe] ON | OFF
Example:
"SYST:COMM:RDEV:PMET:AZER:STAT ON"
Features:
*RST value:
SCPI:
OFF
conforming
SYSTem:COMMunicate:RDEVice:PMETer:TYPE
This command selects the external power meter type.
Syntax:
SYSTem:COMMunicate:RDEVice:PMETer:TYPE <name>
<name>::= ’NRVD’
Example:
"SYST:COMM:RDEV:PMET:TYPE ’NRVD’"
Features:
*RST value:
SCPI:
-
device-specific