Specifications

ZVx SYSTem Subsystem
1043.0009.50 3.131 E-15
COMMAND PARAMETER UNIT COMMENT
:PRESet
:SET
:TIME
:VERSion?
--
<block>
0...23, 0...59, 0...59 --
query only
SYSTem:COMMunicate:AKAL[:STATe]
This command switches the control of the AutoKal box on and off.
Syntax:
SYSTem:COMMunicate:AKAL[:STATe] ON | OFF
Example:
"SYST:COMM:AKAL ON"
Features:
*RST value:
SCPI:
– (no influence on this parameter)
device-specific
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess
This command changes the IEC/IEEE-bus address of the unit.
Syntax: SYSTem:COMMunicate:GPIB[:SELF]:ADDRess 0 to 30
Example: "SYST:COMM:GPIB:ADDR 18"
Features: *RST value: - (no influence on this parameter)
SCPI: conforming
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator
This command changes the receive terminator of the device.
Syntax: SYSTem:COMMunicate:GPIB[:SELF]:RTERminator LFEOI | EOI
Example: "SYST:COMM:GPIB:RTERM EOI"
Features: *RST value: LFEOI
SCPI: device-specific
The analyzer features a DME-channel for communication via IEC/IEEE-bus. This guarantees
maximum speed for the transfer of commands and data. The parser for command decoding
integrated in the device is activated by the terminator only after the command is completely
transferred. In order to make this possible for the transfer of binary data as well , the terminator
recognition has to be reset to the EOI signal before transfer starts. Readout of binary data does not
require such a reset.
SYSTem:COMMunicate:GPIB: RDEVice[:PRINter<1|2>]:ADDRess
This command changes the IEC/IEEE-bus address of the unit which is selected as hardcopy device
1 or 2, provided that the IEC/IEEE-bus interface of this unit is activated.
Syntax: SYSTem:COMMunicate:GPIB:RDEVice:PRINter<1|2>:ADDRess 0 to 30
Example: "SYST:COMM:GPIB:RDEV2:ADDR 5"
Features: *RST value: 4
SCPI: conforming