Specifications

STATus Subsystem ZVx
1043.0009.50 3.126 E-15
STATus:QUEStionable:FREQuency[:EVENt?]
This command queries the contents of the EVENt section of the STATus:QUEStionable:FREQuency
register.
Syntax:
STATus:QUEStionable:FREQuency[:EVENt?]
Example:
"STAT:QUES:FREQ?"
Characteristics:
*RST value:
SCPI:
-
device-specific
The contents of the EVENt section are cleared on reading out.
STATus:QUEStionable:FREQuency:CONDition?
This command queries the CONDition section of the STATus:QUEStionable:FREQuency register.
Syntax:
STATus:QUEStionable:FREQuency:CONDition?
Example:
"STAT:QUES:FREQ:COND?"
Characteristics:
*RST value:
SCPI:
–
device-specific
The contents of the CONDition section are not cleared on reading out.
STATus:QUEStionable:FREQuency:ENABle
This command sets the bits of the ENABle section of the STATus:QUEStionable:FREQuency
register.
Syntax:
STATus: QUEStionable:FREQuency:ENABle 0 to 65535
Example:
"STAT:QUES:FREQ:ENAB 65535"
Characteristics:
*RST value:
SCPI:
–
device-specific
The ENABle register enables the events of the corresponding EVENt section selectively for the sum
bit in the status byte.
STATus:QUEStionable:FREQuency:PTRansition
This command sets the edge detectors of all bits of the STATus:QUEStionable:FREQuency register
for the transitions of the CONDition bit from 0 to 1.
Syntax:
STATus: QUEStionable:FREQuency:PTRansition 0 to 65535
Example:
"STAT:QUES:FREQ:PTR 65535"
Characteristics:
*RST value:
SCPI:
–
device-specific
STATus:QUEStionable:FREQuency:NTRansition
This command sets the edge detectors of all bits of the STATus:QUEStionable:FREQuency register
for the transitions of the CONDition bit from 1 to 0.
Syntax:
STATus: QUEStionable:FREQuency:NTRansition 0 to 65535
Example:
"STAT:QUES:FREQ:NTR 65535"
Characteristics:
*RST value:
SCPI:
–
device-specific