Specifications

ZVx SOURce Subsystem
1043.0009.50 3.121 E-15
SOURce<1...4>: POWer:CORRection:LLISt:STATe
This command defines whether the power loss list should be used for a power calibration.
Syntax:
SOURce<1...4>:POWer:CORRection:LLISt:STATe ON | OFF
Example:
"SOUR:POW:CORR:LLIS:STAT ON"
Features:
*RST value:
SCPI:
OFF
conforming
SOURce<1...4>:FREQuency[:CW|FIXed]
This command defines the CW-frequency for the POWER SWEEP and TIME SWEEP modes.
Syntax:
SOURce<1...4>: FREQuency[:CW|FIXed] <numeric_value>
<numeric_value>::=9kHz...4GHz
Example:
"SOURC2:FREQ 1GHz"
Features:
*RST value:
SCPI:
-
conforming
SOURce<1...4>:FREQuency:CONVersion:ARBitrary:IFRequency
This command defines the frequency range of the internal generator for frequency-converting
modes.
Syntax:
SOURce<1...4>:FREQuency:
CONVersion:ARBitrary:IFRequency
<numeric_value>,<numeric_value>,
<numeric_value>, CW | FIXed | SWEep"
Example:
"SOUR:FREQ:CONV:ARB:IFR 1,1,10MHz"
Features:
*RST-value:
SCPI:
1,1,0
device-specific
The parameters are sorted as follows (see. Section 2.4.1.2.3, “General Frequency Configurations”):
Numerator
Denominator
Offset
Sweep mode or fixed frequency
SOURce<1...4>:FREQuency:CONVersion:ARBitrary:EFRequency<1|2>
This command defines the frequency range of the external generator for frequency-converting
modes.
Syntax:
SOURce<1...4>:FREQuency:
CONVersion:ARBitrary:
EFRequency<1|2>
<ON|OFF>,<numeric_value>,
<numeric_value>,<numeric_value>,
CW | FIXed | SWEep "
Example:
"SOUR:FREQ:CONV:ARB:EFR ON,1,1,10MHz"
Features:
*RST-value:
SCPI:
0
device-specific
The parameters are sorted as follows (see. Section 2.4.1.2.3, “General Frequency Configurations”):
Numerator
Denominator
Offset
Sweep mode or fixed frequency