Specifications

ZVx SOURce Subsystem
1043.0009.50 3.119 E-15
SOURce<1...4>: POWer:SPAN
This command defines the level display range of the analyzer in the level sweep mode.
Syntax:
SOURce<1...4>: POWer:SPAN <numeric_value>
<numeric value> ::= 0dBm to 25 dB (device-specific)
Example:
"SOUR:POW:SPAN 10dB"
Features:
*RST value:
SCPI:
MAXimum
conforming
SOURce<1...4>: POWer:STARt
This command defines the start level in the level sweep mode.
Syntax:
SOURce<1...4>: POWer:STARt <numeric_value>
<numeric value> ::= –25dBm to 0dBm (device-specific)
Example:
"SOUR:POW:STARt -10dBm"
Features:
*RST value:
SCPI: conforming
SOURce<1...4>: POWer:STOP
This command defines the stop level in the level sweep mode.
Syntax:
SOURce<1...4>: POWer:STOP <numeric_value>
<numeric value> ::= –25dBm to 0dBm (device-specific)
Example:
"SOUR:POW:STOP -10dBm"
Features:
*RST value:
SCPI: conforming
[SENSe[1...4]:]CORRection:POWer:DATA
This command is used for reading and writing power correction values for a receiver channel.
The <string> parameter may assume the following values:
"B1" Correction data for wave b1 at port 1
"INPUTB1" Correction data for wave b1 at input b1
"B2" Correction data for wave b2 at port 2
"INPUTB2" Correction data for wave b2 at input b2
"IFREF" Correction data for reference input a1 on rear panel
"A1REF" Correction data for reference input a1 (ZVM and ZVK only)
"A2REF" Correction data for reference input a2 (ZVM and ZVK only)
Syntax:
[SENSe[1...4]:]CORRection:POWer:DATA <string>,<block> |
<numeric_value>...
Example:
"CORR:POW:DATA "B1",<block>"
Features:
*RST value:
SCPI:
-
device-specific