Specifications

SENSe Subsystem ZVx
1043.0009.50 3.112 E-15
3.6.14.9 SENSe:SWEep Subsystem
This subsystem controls the sweep parameters.
COMMAND PARAMETER UNIT COMMENT
[SENSe<1..4>]
:SWEep
:TIME
:AUTO
:COUNt
:POINts
:SPACing
:STEP
:PDECade
:DIRection
<numeric_value>
<Boolean>
<numeric_value>
<numeric_value>
LINear | LOGarithmic
<numeric_value>
<numeric_value>
UP | DOWN
S
--
--
--
--
HZ
--
[SENSe[1 to 4]:]SWEep:TIME
This command defines the duration of the sweep.
Syntax: [SENSe[1 to 4]:]SWEep:TIME <numeric_value>
<numeric_value>::= 5ms to 1000s
Example: "SWE:TIME 10s"
Features: *RST value - (AUTO is set to ON)
SCPI: conforming
If SWEep:TIME is directly programmed, the automatic coupling is switched off.
[SENSe[1 to 4]:]SWEep:TIME:AUTO
This command controls the automatic coupling of the sweep time to the frequency span or to the
bandwidth settings.
Syntax: [SENSe[1 to 4]:]SWEep:TIME:AUTO ON | OFF
Example: "SWE:TIME:AUTO ON"
Features: *RST value: ON
SCPI: conforming
If SWEep:TIME is directly programmed, the automatic coupling is switched off.
[SENSe[1 to 4]:]SWEep:COUNt
This command defines the number of sweeps started by "single sweep".
Syntax: [SENSe[1 to 4]:]SWEep:COUNt <numeric_value>
<numeric_value>::= 0 to 32767
Example: "SWE:COUNT 64"
Features: *RST value: 0
SCPI: conforming
This parameter defines the number of sweeps or the number of averagings. In the average mode,
the value 0 defines a running averaging of the measured data over 10 sweeps.