Specifications

SENSe Subsystem ZVx
1043.0009.50 3.104 E-15
[SENSe[1...4]:]FREQuency:MODE
This command determines which command groups are used for setting the frequency of the
analyzer.
Syntax: [SENSe[1...4]:]FREQuency:MODE CW | FIXed | SWEep | SEGMent
Example: "FREQ:MODE SWE"
Features: *RST value: SWE
SCPI: conforming
For CW and FIXed, the frequency setting is via command FREQuency:CW. In the SWEep mode, the
setting is via the commands FREQuency:STARt, STOP, CENTer and SPAN.
[SENSe[1 to 4]:]FREQuency:CW|FIXed
This command sets the frequency of the analyzer for CW operation.
Syntax: [SENSe[1 to 4]:]FREQuency:CW|FIXed <numeric_value>
<numeric value> ::= model-dependent range (see table at the beginning of
this subsystem)
Example: "FREQ:CW 100MHz"
Features: *RST value: –
SCPI: conforming
The commands FREQuency:CW and FREQuency:FIXed are equivalent.
[SENSe[1...4]:]FREQuency:CONVersion
This command selects frequency-converting measurement modes (second harmonic, third
harmonic, mixer measurements or arbitrary frequency-converting modes).)
Syntax:
[SENSe[1...4]:]FREQuency:CONVersion FUNDamental | SHARmonic |
THARmonic | MIXer | ARBitrary
Example:
"FREQ:CONV THAR"
Features:
*RST value:
SCPI:
FUNDamental
device-specific
[SENSe[1...4]:]FREQuency:CONVersion:ARBitrary
This command defines the frequency range of the receiver for a frequency-converting measurement
mode.
Syntax:
[SENSe[1...4]:]FREQuency:CONVersion:
ARBitrary
<numeric_value>,<numeric_value>,
<numeric_value>, CW | FIXed |
SWEep"
Example:
"FREQ:CONV:ARB 1,1,10MHz,SWE"
Features:
*RST value:
SCPI:
1,1,0
device-specific
The parameters are sorted as follows (see Section 2.4.1.2.3, "General Frequency Configurations"):
numerator,
denominator,
offset,
sweep or fixed frequency.