Specifications

ZVx SENSe Subsystem
1043.0009.50 3.103 E-15
[SENSe[1 to 4]:]FREQuency:CENTer
This command defines the center frequency of the analyzer.
Syntax: [SENSe[1 to 4]:]FREQuency:CENTer <numeric_value>
<numeric value> ::= model-dependent range (see table at the beginning of
this subsystem)
Example: "FREQ:CENT 100MHz"
Features: *RST value: –
SCPI: conforming
[SENSe:]FREQuency:SPAN
This command defines the frequency span of the analyzer.
Syntax: [SENSe:]FREQuency:SPAN <numeric_value>
<numeric value> ::= model-dependent range (see table at the beginning of
this subsystem)
Example: "FREQ:SPAN 10MHz"
Features: *RST value: MAXimum
SCPI: conforming
[SENSe:]FREQuency:STARt
This command defines the start frequency of the analyzer.
Syntax: [SENSe:]FREQuency:STARt <numeric_value>
<numeric value> ::= model-dependent range (see table at the beginning of
this subsystem)
Example: "FREQ:STAR 20MHz"
Features: *RST value: 9kHz or 300kHz (passive or active test set)
SCPI: conforming
[SENSe:]FREQuency:STOP
This command defines the stop frequency of the analyzer.
Syntax: [SENSe:]FREQuency:STOP <numeric_value>
<numeric value> ::= model-dependent range (see table at the beginning of
this subsystem)
Example: "FREQ:STOP 2000MHz"
Features: *RST value: model-dependent (see table at the beginning of
this subsystem)
SCPI: conforming