Specifications

SENSe Subsystem ZVx
1043.0009.50 3.100 E-15
[SENSe[1...4]:]CORRection:POWer:DATA
This command is used for reading and writing power correction values for a receiver channel.
The <string> parameter may assume the following values:
"B1" Correction data for wave b1 at port 1
"INPUTB1" Correction data for wave b1 at input b1
"B2" Correction data for wave b2 at port 2
"INPUTB2" Correction data for wave b2 at input b2
"IFREF" Correction data for reference input a1 on rear panel
"A1REF" Correction data for reference input a1 (ZVM and ZVK only)
"A2REF" Correction data for reference input a2 (ZVM and ZVK only)
Syntax:
[SENSe[1...4]:]CORRection:POWer:DATA <string>,<block> |
<numeric_value>...
Example:
"CORR:POW:DATA "B1",<block>"
Features:
*RST value:
SCPI:
-
device-specific
[SENSe[1...4]:]CORRection:POWer:DATE?
This command queries the date at which the active power calibration was recorded.
Syntax:
[SENSe[1...4]:]CORRection:POWer:DATE?
Example:
"CORR:POW:DATE?"
Features:
*RST value:
SCPI:
-
device-specific