Specifications
ZVx SENSe Subsystem
1043.0009.50 3.95 E-15
[SENSe[1...4]:]CORRection:CKIT:<CAL-Kit-Typ>:SELect
This command selects a defined calibration kit from the specified connector family.
Syntax:
[SENSe[1...4]:]CORREction:CKIT:<CAL-Kit-Typ>:SELect <string>
Example:
"CORR:CKIT:N50:SEL ‘ZCAN’
Features:
*RST value:
SCPI:
-
device-specific
[SENSe[1...4]:]CORRection:CKIT:USER<1|2>:IMPedance
This command sets the impedance of the USER calibration kit.
Syntax:
[SENSe[1...4]:]CORREction:CKIT:USER<1|2>:IMPedance <numeric_value>
Example:
"CORR:CKIT:USER2:IMP 40 OHM
Features:
*RST value:
SCPI:
50 Ω
device-specific
[SENSe[1...4]:]CORRection:CKIT:USER<1|2>:WGUIde[:STATe]
This command switches on or off waveguide calibration for the respective calibration kit.
The suffix of SENSe has no meaning.
Syntax:
[SENSe[1...4]:]CORRection:CKIT:USER<1|2>:WGUide[:STATe] ON | OFF
Example:
"CORR:CKIT:USER:WGU ON"
Features:
*RST value:
SCPI:
OFF
device-specific
[SENSe[1...4]:]CORRection:CKIT:USER<1|2>:CFRequency
This command sets the cutoff frequency for the USER calibration kit.
Syntax:
[SENSe[1...4]:]CORREction:CKIT:USER<1|2>: CFRequency <numeric_value>
Example:
"CORR:CKIT:USER2:CFR 1 GHz
Features:
*RST value:
SCPI:
0 Hz
device-specific
[SENSe[1...4]:]CORRection:CKIT:N50|N75
This command selects a standard from the N-calibration kit (N50 or N75).
Syntax:
[SENSe[1...4]:]CORRection:CKIT:N50|N75 MMTHrough | MFTHrough |
FFTHrough | MMLINE1 | MFLINE1 |
FFLINE1 | MMLINE2 | MFLINE2 |
FFLINE2 | MMATten | MFATten |
FFATten | MMSNetwork |
MFSNetwork | FFSNetwork | MOPEn
| FOPEn | MSHort | FSHort |
MREFlect | FREFlect | MMATch |
FMATch | MSMatch | FSMatch
[,<string>]
Example:
"CORR:CKIT:N50 FFTH"
Features:
*RST value:
SCPI:
–
device-specific