Specifications

SENSe Subsystem ZVx
1043.0009.50 3.94 E-15
[SENSe[1...4]:]CORRection:CKIT:INSTall
The command installs a calibration kit data set from a file.
Syntax:
[SENSe[1...4]:]CORREction:CKIT:INSTall <filename>
Example:
"CORR:CKIT:INST ‘A:\mykit.ck’"
Features:
*RST value:
SCPI:
-
device-specific
[SENSe[1...4]:]CORRection:CKIT:<CAL-Kit-Typ>:<Standard>
The command configures the parameters of the different standards.
Syntax:
[SENSe[1...4]:]CORREction:CKIT:
<CAL-Kit-Typ>:<Standard>
string>,
<string>,
<numeric_value>,
<numeric_value>,
<numeric_value>,
<numeric_value>,
<numeric_value>,
<numeric_value>,
<numeric_value>,
<numeric_value>,
OPEN | SHORT
Example:
"CORR:CKIT:N50:MOP
‘ZCAN’,‘123456/001’,0Hz,3GHz,5mm,0.002,24,1.8,0.1,0"
Features:
*RST value:
SCPI:
-
device-specific
Depending on the standard, not all values are used in the list. Their meaning in the given sequence is as
follows:
string>: CAL kit name max. 10 characters
<string>: Serial number max. 15 characters
<numeric_value>: Lower frequency limit of the standard, unit Hz
<numeric_value>: Upper frequency limit of the standard, unit Hz
<numeric_value>: Electrical length of the standard, unit m
<numeric_value>: Loss
<numeric_value>: Polynomial coefficient C0/L0 for parasitic capacitance / inductance, no unit
<numeric_value>: Polynomial coefficient C1/L1 for parasitic capacitance / inductance, no unit
<numeric_value>: Polynomial coefficient C2/L2 for parasitic capacitance / inductance, no unit
<numeric_value>: Polynomial coefficient C3/L3 for parasitic capacitance / inductance, no unit
OPEN | SHORT: Approximate modelling