Specifications
EPSON PowerSpan DT
Error
messages (continued)
drive controller; check all appropriate connections
drive
contmfler;
check all
appropftate
connections
the
~syboard
optlon In Setup to
OFF
BOARD
PARITY ERROR
ADDR
t-1
=
(=xX)
ON BOARD
PARITY
ERROR
ADDR
(=I
-
(x==)
ISA NMI messages
ISA
NMI
meeeage
Deecription
Memory Parity Error at
Memory failed; if the memory location can be
xXxXx
determined. it
ie
d&Wed
ae
xxxxx
if not, the
messags
i$ Memo4
P&y
Error
??I?
I/O
Card Parity Error at
I
An
expaneion
card
failed;
if
the
address
can be
xxmx
deten&ned,
it
ie
displayed
ae
XKJXX
tl
not, the
message Is
I/o
Card
Paffty
Ermr
7717
DMA Bus Time-out
A device
has
driven the DMA bus signal for more
than 7.8 microseconds
Tested Operating Environments
Although the system will run most software applications,
the following operating environments
have
been tested for
compatibility with this system.
Microsoft MS-DOS
Novell DR DOS 6.0
Novell NetWare
2.2,3.12,
and 4.01
Novell NetWare Lite 1.1
IBM OS/2 2.1
SC0
UNIX release 3.2, version 4.2
SC0
Open Desktop 3.0
Microsoft Windows 3.0 and 3.1
Microsoft Windows for WorkGroups 3.11
Microsoft Windows NT 3.1
NextStep
version 3.2
LAN Manager
This system has also received Novell’s ‘Yes, NetWare tested
and approved” certification as a workstation and file server.
As new environments become available, these also will be
tested and certified.
Installation/Support Tips
System Power Requirements
If the power cord supplied with the system is not compatible
with the electrical outlet, obtain a cord that
meets these
criteria:
P
The cord must be rated for at least 125% of the current
rating of the AC voltage system.
Cl
The cord must be less than 4.5 meters (14.8 feet) long.
Cl
The connector that plugs into the electrical outlet must be
an appropriately designed male grounding-type
connector.
Ll
The connector that plugs into the computer must be an
IEC type CEE-22 female connector.
Do not use or attempt to modify the supplied AC power cord
if it is not the type required for use in your region.
To avoid permanent damage to the computer, be sure the
voltage selector switch is set to the correct input line voltage
before you turn on the power. Verify that the voltage selector
switch is set to the correct setting. The 115 VAC setting is
appropriate for line source voltages between 100 and 120
VAC. If the line source voltage in your location is between
200 and 240 VAC, make sure you set the switch to 230 VAC.
To avoid damage to the
system
board or power supply, do
not exceed a total of 145 Watts power draw.
?
EPSON PowerSpan DT - 10
3/94