User`s guide

SD command parameters (continued)

Parameter Mode

Function

/K Keyboard only Sets the program so a mouse

mode cannot be used, even if you have

installed one. In default mode, you

can use a mouse as long as a

mouse driver is loaded.

/M Monochrome Displays the program in black and

display mode white only. In default mode, color

monitors will display in color. Run

the program in this mode if you

have redirected the console

output to a serial port.

/N Non-target Allows you to run the EISA

modeling mode Configuration utility in non-target

modeling mode; see page 3-31 for

more information.

/P Permanent Reboots the system instead of

command exiting to your operating system.

interpretermode Use this mode if there is no

COMMAND.COM file installed on

your hard disk drive.

Using the CF Command

The CF command starts the EISA Configuration utility, but you

cannot run any other utilities. If you want to run the EISA

Configuration utility from your hard disk, first follow the

instructions under “Copying the Configuration Files to a Hard

Disk” on page 3-36.

Then follow these steps to use the CF command:

To run the utility from a diskette, insert the System

Configuration diskette in drive A and log onto drive A.

To run the utility from a hard disk, log onto the drive and

directory where you copied the configuration files.

3-34 Running the EISA Configuration Utility