User`s guide

Built-in SCSI controller options (continued)
Option
Data FIFO
Threshold
Settings
100%*
75%
50%
00%
Description
This option sets the
percentage of data FIFO
used by the controller to
match SCSI and host
system data trader rates
The default setting of 100%
is usually sufficient.
SCSI Channel 7*
A and B, 6
Host Adapter 5
SCSI ID 4
3
2
1
0
Select the SCSI ID for the
indicated built-in SCSI
interface (host adapter);
normally you should assign
ID 7 to the host adapter, IDS
0 and 1 to SCSI hard disk
drives, and the other IDs to
other devices, if present.
Because channels A and B
are separate SCSI buses,
you can assign each host
adapter as lD 7
SCSI Channel Enabled*
Select Enabled to generate
A and B, Disabled
parity checking on the host
SCSI Bus Parity
adapter; if an attached
Check
SCSI device does not
support parity checking, set
this option to Disabled
SCSI Channel 256 milliseconds
This option sets the amount
A and B, 128 milliseconds
of time the host adapter
SCSI Selection 64 milliseconds
uses to complete the SCSI
Time 32 milliseconds
selection phase; fader
times speed up the SCSI bus
but all devices on the SCSI
bus must be compatible
with the speed you select
SCSI Channel Enabled*
Select Enabled to reset the
A and B, Disabled
SCSI bus each time you turn
SCSI Bus Reset
on or reset the computer;
at Power-on
this option should always
be set to Enabled
3-22 Running the EISA Configuration Utility