User`s guide

SETUP program options (continued)
Option
Settings
POST Setup
Enabled*
Prompt Disabled
Description
Set to Enabled to display the
prompt to run the SETUP program
when you turn on or reset your
computer; select Disabled to
prevent display of the prompt.
(You can still press F1 to run
SETUP if you disable the prompt.)
See page 2-2 for more
information.
Boot Device Diskette or Hard
Drive *
Hard Drive Only
Select the device(s) from which
you want to be able to boot your
system; the setting isignored if
the diskette drive iscontrolled by
a controlleron an option card
Base Memory
640 KB*
Displays the size of the base
512 KB
memory; setting is 640 KB unless
there is a base memory failure or
you reassigned the base memory
between 512 KB and 640 KB in the
Base Memory option described
below
Extended
Memory
[memory size]
Displays the amount of extended
memory above 1MB, including
memory installed on SIMMs and
any memory option cards you
cannot change this setting
Base Memory Enabled*
Set to Enabled to assign the base
Above 512K Disabled
memory addressfrom 512 KB to
640 KB to memory on the system
board; set to Disabled if you
install an option card that
reserves these addresses for its
own use
Speaker Enabled*
Disabled
Set to Enabled to turn on the
computer’s built-in speaker; set
to Disabled to turn off the
speaker (cannot be turned on
by application software if
Disabled)
Running the SETUP Program 2-9