User`s guide

Your computer’s SETUP program is stored in the system BIOS
ROM. You can run SETUP whenever you turn on or reset the
computer, regardless of whether you have installed an
operating system.
Note
Any settings you make using the EISA Configuration utility
override those you set using SETUP.
Starting the Program
Follow these steps to run SETUP:
1. Turn on the computer or press the reset button. You see the
memory counts for the memory test and then the power-on
diagnostic tests. You may also see this prompt:
Press Spacebar to Abort Memory Test
If you want to skip the memory test to shorten the time it
takes to enter SETUP, press the spacebar.
(If you press
Ctrl Alt Del to reset the computer, it does not
perform the memory test.)
2. If the power-on diagnostic tests do not find errors, you hear
a tone code and may see the following prompt:
To continue press: . . . . . . . SPACEBAR
To configure system press: . . . F1
The prompt remains on the screen for four seconds.
Press
F1 to run SETUP.
2-2 Running the SETUP Program