User`s guide

Position the drive in the bay so the components face down

and the ribbon and power sockets face outward. Align each

plastic slide rail with the guide rails inside the bay you plan

to use; then slide the drive into the bay until the slide rails

lock in place, as shown below.

slide rail

ribbon and

powercable

Repeat steps 4 through 8 to install any other SCSI drives in

the lower drive bays.

If you installed four or fewer drives, go to the next section.

If you need to install a fifth or sixth SCSI drive in the upper

internal bays, follow the instructions on page 7-10 to remove

the IDE drive bay assembly. Then return to page 7-22 for

instructions on connecting the ribbon and power cables to your

drive(s).

Installing and Removing Disk Drives 7-21