User`s guide

The table below lists the jumper settings and their functions.
Main system board jumpersettings
Jumper Jumper
number
Description setting Function
E0190 FLASH memory 1 to 2* Normal boot
2 to 3 Enables FLASH memory BlOS for
recovery operation
E0290 Video controller 1 to 2* Enables onboard video controller
2 to 3 Disables onboard video
controller so you can install a
video controlleron an option
card
E0291 Diskette
write-
protection
1 to 2* Enablesread-write capability
(read/write mode) for any
diskette drive connected to the
built-in controller
2 to 3 Enableswrite-protection (read-
only mode) for any diskette drive
connected to the built-in
controller
E0292 NVRAM 1 to 2* Normal non-volatile RAM
operation
2 to 3 Changes EISA configuration or
SETUP values stored in
non-volatile RAM to theirdefault
values
E0390 Password 1 to 2* Enables power-on password
operation
2 to 3 Disables and clears the
power-on password
E0391 SlMM Bank 0 1 to 2* 1MB, 2MB, 4MB, or 8MB SlMMs
are installed in Bank 0
2 to 3 16MB or 32MB SIMMs are
installed in Bank 0
E0392 SlMM Bank 1 1 to 2* 1MB, 2MB, 4MB, or 8MB SlMMs
are installed in Bank 1
2 to 3 16MB or 32MB SIMMs are
installed in Bank 1
Installing and Removing Options 6-19