Technical data

4-22
Hardkey and Softkey Reference
PRINT COLOR. prints the displayed measurement results in color.
PRINT COLORS. is used to select the print colors menu.
PRINT: MONOCHROME. sets the print command to default to a black and white printer.
PRINT MONOCHROME. prints the displayed measurement results in black and white.
PRINT SEQUENCE. prints any sequence currently in memory to a compatible printer.
PRINTER BAUD RATE. sets the serial port data transmission speed for prints.
PRINTER FORM FEED. sends a conditional form feed to the printer.
PRINTER PORT. configures the port the analyzer will use to communicate with the printer.
PRNTR PORT GPIB. directs prints to the GPIB port and sets the GPIB address the analyzer will use to communicate with
the printer.
PRNTR PORT PARALLEL. configures the analyzer for a printer that has a parallel (centronics) interface.
PRNTR PORT SERIAL. configures the analyzer for a printer that has a serial (RS-232) interface.
PRNTR TYPE [DESKJET]. sets the printer type to the DeskJet series.
PRNTR TYPE [EPSON-P2]. sets the printer type to Epson compatible printers, which support the Epson ESC/P2 printer
control language.
PRNTR TYPE [LASERJET]. sets the printer type to the LaserJet series.
PRNTR TYPE [PAINTJET]. sets the printer type to the PaintJet.
PRNTR TYPE [THINKJET]. sets the printer type to the ThinkJet or QuietJet.
PULSE VALUE. sets the two response points at which the pulse width is calculated. Pulse value is the percentage of
pulse height where the width is to be measured.
PULSE WIDTH. calculates the width of a pulse.
PWR DAC on OFF. sets the power level directly from the power DAC.
PWR LOSS on OFF. turns on or off power loss correction. Power loss correction should be used when the power output
is measured by a directional coupler. Enter the power loss caused by the coupled arm with the LOSS/SENSR LISTS
softkey submenus described below.
PWR RANGE AUTO man. toggles the power range mode between auto and manual. Auto mode selects the power range
based on the power selected. Manual mode limits power entry to within the ±6to −12 dB selected range.
PWRMTR CAL [ ]. leads to the power meter calibration menu which provides two types of power meter calibration,
continuous (each sweep) and single-sample (one sweep).
PWRMTR CAL [OFF]. turns off power meter calibration, terminate a power meter calibration sweep.
R. measures the absolute power amplitude at input R.
R+jX MKR. converts the active marker values into rectangular form. The complex impedance values of the active
marker are displayed in terms of resistance, reactance, and equivalent capacitance or inductance. This is the default
Smith chart marker. Each of the range softkeys will have different ranges dependent on the analyzer model and options
installed.
RANGE 0 -15 TO +10. selects power range 0 when in manual power range.
RANGE 1 -25 TO 0. selects power range 1 when in manual power range.
RANGE 2 -35 TO -10. selects power range 2 when in manual power range.
RANGE 3 -45 TO -20. selects power range 3 when in manual power range.
RANGE 4 -55 TO -30. selects power range 4 when in manual power range.
RANGE 5 -65 TO -40. selects power range 5 when in manual power range.
RANGE 6 -75 TO -50. selects power range 6 when in manual power range.
RANGE 7 -85 TO -60. selects power range 7 when in manual power range.
RANGE 4 -55 TO -30. selects power range 8 when in manual power range.
RANGE 5 -65 TO -40. selects power range 9 when in manual power range.