User's Guide

Power light Lamp light Temp light Status and solution
Red Off Red Projector has overheated and turned off. Leave
it turned off to cool down. Once the Temp light
turns off and the power light turns orange (after
about five minutes), try the suggestions below:
• Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby
objects.
• Clean or replace the air filter.
• If operating the projector at high altitude, turn
on High Altitude Mode.
• If the problem persists, unplug the projector
and contact Epson for help.
Red Flashing red Off Lamp has a problem.
• Check to see if the lamp is burned out,
broken, or installed incorrectly. Reseat or
replace the lamp as necessary.
• Clean or replace the air filter.
• If operating the projector at high altitude, turn
on High Altitude Mode.
• If the problem persists, unplug the projector
and contact Epson for help.
Light status Flashing orange Off Replace the lamp soon to avoid damage. Do
varies not continue using the projector.
Red Off Flashing red A fan or sensor has a problem. Turn the
projector off, unplug it, and contact Epson for
help.
Red or flashing Flashing red Flashing red Internal projector error. Turn the projector off,
red unplug it, and contact Epson for help.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
117