User's Guide

76 Using the Projector on a Network
For a wireless connection, make sure you’ve installed the optional
Wireless 802.11g/b/a Module, as described on page 78. Then follow
the steps in this chapter to use Quick Wireless Connection (Windows
only) or configure your projector and network. See the EasyMP
Network Projection Operation Guide for instructions on installing the
EasyMP Network Projection software. The EasyMP Network
Projection Operation Guide also contains instructions on using the
software to project over the network.
Connecting to a Wired Network
With an Ethernet cable, you can connect the projector to your
network and configure it with an IP address.
1. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the
LAN port on the projector as shown. To ensure
proper data transmission, use a shielded, Category-5 cable or
better.
2. Connect the other end to your Ethernet hub or router.
3. Turn on the projector.
4. Press the
Menu button, select the Network menu, then press
Enter.
5. Choose
Network Configuration and press Enter.