Operation Guide
Table Of Contents
- Front Cover
- Contents
- EasyMP Summary
- Installing the Software
- Connecting with EMP NS Connection
- Convenient EMP NS Connection Functions
- Connecting to a Projector on a Different Sub-net
- Setting the EMP NS Connection Operation
- Using a Computer to Set Up, Monitor and Control Projectors
- Presentations Using PC Free
- Preparing a Scenario (Using EMP SlideMaker2)
- Appendix
- Copyrights and Trademarks
Troubleshooting
89
f Network settings are not restored after cutting the connection to the computer with EMP NS Connection.
Failed to acquire network adapter information. Check the following points.
• Is a network adapter installed on the computer?
• Is the driver for the network adapter used installed on the computer?
After checking, restart the computer and connect again.
If you still cannot connect, check the network settings on the computer and the network settings on the
projector.
For details on the network settings to be made on the projector, see your User’s Guide.
One or more connected projectors do not support
resolutions greater than SXGA. Reduce the screen
resolution and reconnect.
There is an PowerLite 735c projector in the connection destination. Change the computer's screen resolution
to SXGA (1280 ^ 1024) or less.
There are projectors that do not respond.
You cannot connect to multiple projectors simultaneously. Check the network settings on the computer and the
network settings on the projector.
For details on the network settings to be made on the projector, see your User’s Guide.
Enter the keyword displayed in the projector. Check the projector's keyword displayed on the EasyMP standby screen, and enter the projector's keyword.
Check Remedy
Are you manually connecting to a wireless LAN when
the computer starts up?
Try connecting to the wireless LAN manually.
Check Remedy
Quick Connection Mode