User's Guide

Using the Projector on a Network 95
3. Choose Mail, then press Enter. You see a screen like the
following:
4. For the Mail Notification setting, select
On to receive email
notifications, then press
Enter.
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server’s port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
Address fields, then enter the e-mail address
and the contents of the message that you will receive when a
problem or warning occurs. You can register up to three addresses.
You can enter up to 32 alphanumeric characters for the e-mail
address.
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Communication On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).